Hi,
I'm using a ST1 X model 2019.
On the OMNI interface I set the brake sensor to 0 (top left).
Using that setting the delay in between a brake action and next assistance is so long, making the ride unpleasant.
I mean when I press the brake, electric assistance is switch off (which is normal) but the delay to reactivate the assistance since the brake has been released is really too long.
I mean when you ride, you pull the brake but 0.3 sec later you can pedal again asking for assistance ...
By setting the brake sensor slider to the right I didn't noticed any change (it should be worst)
my question are :
What is the real effect of the break sensor setting on bike behavior ?
Is there a way to fully disable brake sensor ?
Could it be a torque sensor issue ?
Regards,
I'm using a ST1 X model 2019.
On the OMNI interface I set the brake sensor to 0 (top left).
Using that setting the delay in between a brake action and next assistance is so long, making the ride unpleasant.
I mean when I press the brake, electric assistance is switch off (which is normal) but the delay to reactivate the assistance since the brake has been released is really too long.
I mean when you ride, you pull the brake but 0.3 sec later you can pedal again asking for assistance ...
By setting the brake sensor slider to the right I didn't noticed any change (it should be worst)
my question are :
What is the real effect of the break sensor setting on bike behavior ?
Is there a way to fully disable brake sensor ?
Could it be a torque sensor issue ?
Regards,